High-frequency interconnects to 40 GHz

FEATURES

  • Optional bullet adaptors in two standard lengths
  • Performance up to 40 GHz
  • Compensates for misalignment in X and Y directions
  • RG 405 (.086" DIA) semi-flexible or 25 AWG rugged solid dielectric microwave cable termination
  • Interfaces for tight, more secure connections

SERIES

RF25S

Solid FEP Dielectric, 25 AWG Microwave Cable Assembly

Features
  • Performance up to 40 GHz
  • End 2 options: SMA, SMP
  • 50 ohm impedance
  • 25 AWG solid dielectric low loss microwave cable
Solid FEP Dielectric, 25 AWG Microwave Cable Assembly

RF405

50 Ohm RF Cable Assembly, 24 AWG Semi-Flexible Cable

Features
  • Performance up to 40 GHz
  • 50 ohm impedance
  • 24 AWG hand-formable, semi-flexible cable (.086" DIA)
  • Straight or right-angle SMA or SMP plug cable terminations
50 Ohm RF Cable Assembly, 24 AWG Semi-Flexible Cable

SMP-B

50 Ohm SMP Jack, Bullet Adaptor

Features
  • Jack bullet adaptor for SMP board mount plugs
  • Allows board spacing of 9.05 mm (.356") or 17.10 mm (.673")
50 Ohm  SMP Jack, Bullet Adaptor

SMP-CA

50 Ohm SMP Jack, Cable Termination

Features
  • SMP cable component
  • 50 ohm impedance
  • Straight or right-angle jacks available on RG 405, CCA-25M or MWC-2550-01 cables
50 Ohm SMP Jack, Cable Termination

SMP-EM

50 Ohm SMP Plug, Edge Mount

Features
  • Compensates for misalignment in X & Y directions
  • Full detent, limited detent and smooth bore
  • 50 ohm impedance
  • Performance up to 40 GHz
50 Ohm SMP Plug, Edge Mount

SMP-TH

50 Ohm SMP Plug, Through-hole

Features
  • Compensates for misalignment in X & Y directions
  • Full detent, limited detent, smooth bore or catcher's mitt
  • 50 ohm impedance
  • Performance up to 40 GHz
50 Ohm SMP Plug, Through-hole

A key component of any high-speed signal path is the interconnect.  Design engineers must identify the right connector (or connectors) and the best performance for the application. At 56 Gbps PAM4 data rates (and higher), connector selection becomes more challenging. Interconnect...
It’s been over a year since we last updated the Samtec homepage. As you may have already noticed, we recently took some time to refresh it. You can see a comparison below of the old homepage (top), vs the new homepage (bottom). The new update puts more attention on our high speed...
If you manufacture overseas and ship into the U.S.A, you may have a longer waiting time in Customs than you would prefer.  Some of this waiting time could be eliminated by becoming part of the Customs Trade Partnership Against Terrorism (C-TPAT), one layer of the U.S. Customs and...
Just about everybody wishes they had more time to pursue a hobby or a side project.  Some aspire to be painters or furniture makers.  Others like to rebuild cars.  Even others enjoy electronics in any form. The Maker Movement attracts and caters to tinkerers, hobbyists, students ...
Demand For High Data Rate As the need for bandwidth continues to increase, so does the need for higher data rates within a system. What was once one to three Gbps, then moved to 4 to 8 Gbps, and now we are approaching 28 Gbps and looking forward to 56 G. This trend was recently [...
View Full Site